If a malfunction in the ECM circuit occurs, the 4WD ECU assembly will output this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1280/82 | Engine Circuit Malfunction | When the following continues for 5 seconds or more:
·
Communication with engine control ECM is operating normally, but engine control system is malfunctioning. |
·
Engine control system ·
4WD ECU assembly |
Check the condition of each related circuit connector before troubleshooting.
Check if the engine control system DTC is output.
| Item | See page | |
|---|---|---|
| for 2AR-FE | w/ Canister Pump Module | ( )
|
| w/o Canister Pump Module | ( )
|
|
| for 2AD-FHV | ( )
|
|
| for 2AD-FTV | for DPF | ( )
|
| for CCo | ( )
|
|
| for 3ZR-FAE | ( )
|
|
| for 3ZR-FE | for K111, K111F | ( )
|
| except K111, K111F | ( )
|
|
| Result | Proceed to | ||
|---|---|---|---|
| Engine control system DTC is not output | A | ||
| Engine control system DTC is output | for 2AR-FE | w/ Canister Pump Module | B |
| w/o Canister Pump Module | C | ||
| for 2AD-FHV | D | ||
| for 2AD-FTV | for DPF | E | |
| for CCo | F | ||
| for 3ZR-FAE | G | ||
| for 3ZR-FE | for K111, K111F | H | |
| except K111, K111F | I | ||
A
B
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>DIAGNOSIS SYSTEM
C
D
E
Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>DIAGNOSTIC TROUBLE CODE CHART
F
Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for CCo)>DIAGNOSTIC TROUBLE CODE CHART
G
H
I