Home › Drivetrain › GF1A TRANSFER / 4WD / AWD › DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM › from 2015.10
RM3090E _52 Drivetrain _008760 GF1A TRANSFER / 4WD / AWD _0048749 DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM J

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM  4WD Warning Light does not Come ON  


CAUTION / NOTICE / HINT

HINT:

Check the condition of each related circuit connector before troubleshooting.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication system DTCs are output.

for LHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Central Gateway ECU)>DIAGNOSIS SYSTEM

for RHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Central Gateway ECU)>DIAGNOSIS SYSTEM

for LHD without Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Central Gateway ECU)>DIAGNOSIS SYSTEM

for RHD without Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD without Central Gateway ECU)>DIAGNOSIS SYSTEM

Result:
Result Proceed to
CAN communication system DTC is not output A
CAN communication system DTC is output (for LHD with Central Gateway ECU) B
CAN communication system DTC is output (for RHD with Central Gateway ECU) C
CAN communication system DTC is output (for LHD without Central Gateway ECU) D
CAN communication system DTC is output (for RHD without Central Gateway ECU) E


HINT:

When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.




A

2.INSPECT 4WD/AWD WARNING LIGHT

B

C

D

E

2.INSPECT 4WD/AWD WARNING LIGHT
a.

Disconnect the G86 4WD ECU assembly connector.


b.

Turn the ignition switch to ON.


c.

for Segment Display Type:

Check that the 4WD/AWD warning light comes on.

OK:

4WD/AWD warning light comes on.



d.

for TFT Display Type:

Check that the 4WD/AWD warning message is displayed.

OK:

The 4WD/AWD warning message is displayed.



Result:
Proceed to
OK
NG



OK

NG

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)