This DTC is stored when a communication error occurs between the radio and display receiver assembly and combination meter assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1324 | Lost Communication with Meter | After the radio and display receiver assembly receives a registration information signal, which is sent by the combination meter assembly when the ignition switch is ACC, 1 or more times, the radio and display receiver assembly cannot receive the signal for 30 seconds or more. | ·
Combination meter assembly ·
Radio and display receiver assembly ·
Harness or connector |
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
When replacing the combination meter assembly, make sure to replace it with a new one.
Disconnect the G159 radio and display receiver assembly connector.
Disconnect the G16 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G159-3 (CNH1) - G16-23 (MSCH) | Always | Below 1 Ω |
| G159-4 (CNL1) - G16-22 (MSCL) | Always | Below 1 Ω |
| G159-3 (CNH1) - Body ground | Always | 10 kΩ or higher |
| G159-4 (CNL1) - Body ground | Always | 10 kΩ or higher |
| G159-3 (CNH1) - G159-4 (CNL1) | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G159-3 (CNH1) - Body ground | Always | Below 1 V |
| G159-4 (CNL1) - Body ground | Always | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the combination meter assembly.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 23 (MSCH) - 22 (MSCL) | Always | 108 to 132 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the radio and display receiver assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (CNH1) - 4 (CNL1) | Always | 108 to 132 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the combination meter assembly.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL
Clear the DTCs.
Check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch to ON and wait 30 seconds.
Operate the steering pad switch assembly and check that the audio tab is displayed on the multi-information display in the combination meter assembly and the audio system can be operated normally.
Audio system returns to normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG