This DTC is output when the multiplex network door ECU detects a power back door sensor assembly RH touch sensor malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B222B | PBD Touch Sensor RH Circuit | This DTC is output when the multiplex network door ECU detects a power back door sensor assembly RH touch sensor malfunction. | ·
Multiplex network door ECU ·
Power back door sensor assembly RH ·
Harness or connector |
If the replacement, removal and installation of the multiplex network door ECU or disconnection of the connectors of the multiplex network door ECU has been performed, initialize the power back door system.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>INITIALIZATION
Clear the DTCs.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC B222B is not output |
| DTC B222B is output |
DTC B222B is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTC B222B is output
Check the Data List for proper functioning of the power back door sensor assembly RH.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| PBD Touch Sensor (Right) | Power back door sensor assembly RH signal | ON, OFF or Open | ON: Power back door sensor assembly RH pressed
OFF: Power back door sensor assembly RH not pressed Open: Power back door sensor assembly RH circuit open |
- |
| Tester Display |
|---|
| PBD Touch Sensor (Right) |
| Result | Proceed to |
|---|---|
| ON and OFF function is normal | A |
| ON and OFF function is not normal, or Open is displayed for power back door sensor assembly RH | B |
A
B
Remove the power back door sensor assembly RH.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR TOUCH SENSOR>REMOVAL
Inspect the power back door sensor assembly RH.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR TOUCH SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the U29 multiplex network door ECU connector.
Disconnect the U10 power back door sensor assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U29-6 (OSR) - U10-1 (OSR) | Always | Below 1 Ω |
| U29-24 (OSE) - U10-2 (OSRE) | Always | Below 1 Ω |
| U29-6 (OSR) or U10-1 (OSR) - Body ground | Always | 10 kΩ or higher |
| U29-24 (OSE) or U10-2 (OSRE) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG