Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › SFI SYSTEM(w/ Canister Pump Module) › from 2015.10
RM3090E _51 Engine / Hybrid System _008378 2AR-FE ENGINE CONTROL _0060196 SFI SYSTEM(w/ Canister Pump Module) L

2AR-FE ENGINE CONTROL  SFI SYSTEM(w/ Canister Pump Module)  PRECAUTION  


INITIALIZATION


NOTICE:
·

If the ECM is replaced, register the ECU communication ID for Immobiliser System (w/o entry and start system).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

·

Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle with motor body components.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION

·

Perform Registration (VIN registration) when replacing the ECM.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>REGISTRATION

·

Make sure to perform Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION




WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:


·

Before using the GTS, read the instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes using the GTS, 2 persons are required. One drives the vehicle, and the other operates the GTS.



DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

After the engine switch is turned off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION