The ECM monitors the signals received from the throttle position sensor No. 1 and stop light switch assembly. As the ECM monitors the STP signal of the stop light switch assembly and the throttle position sensor No. 1, if these signals do not correlate, the DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P060E | Internal Control Module Throttle Position Performance | Either of the following conditions is met (1 trip detection logic):
·
There is an ECM main CPU error. ·
There is an ECM sub CPU error. |
ECM | Comes on | DTC stored |
| Required Sensors/Components | ECM |
| Frequency of Operation | Continuous |
| DMA communication error | Not detected |
| When one of following conditions is met: | Condition 1 or 2 |
| 1. Difference of main throttle position and sub throttle position | 0.3 V or higher |
| 2. Stop light switch signal (CPU) and stop light switch signal (Monitor IC) | Different |
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the engine switch on (IG) and wait for 16 seconds or more.
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>DTC CHECK / CLEAR
Turn the engine switch off and turn the GTS off.
Disconnect the GTS.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Wait 16 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC P060E is output | B |
A
B