Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › INTRUSION SENSOR › from 2015.10
RM3090E _58 Vehicle Interior _008690 THEFT DETERRENT / KEYLESS ENTRY _0050372 INTRUSION SENSOR A

THEFT DETERRENT / KEYLESS ENTRY  INTRUSION SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 81208 3.REMOVE MAP LIGHT SUB-ASSEMBLY

Hide 89732 4.REMOVE THEFT WARNING RADAR SENSOR

a.
E332844

w/ Sliding Roof:

i.

Disconnect the connector.


ii.

Remove the 2 screws and theft warning radar sensor.



b.
E332845

w/o Sliding Roof

i.

Disconnect the connector.


ii.

Remove the 2 screws and theft warning radar sensor.