The power steering ECU assembly receives vehicle speed signals from the brake actuator assembly via CAN communication. The ECU provides appropriate assisting force in accordance with the vehicle speed based on the signals.
If the ECU detects this DTC, it adjusts the amount of power assistance for a speed of 140 km/h (87 mph) and continues system control.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition |
|---|---|---|---|---|---|
| C1541/13 | Vehicle Speed Signal | This DTC is detected when vehicle speed signals via CAN communication are cut off for 3 seconds or more. | ·
Speed sensor circuit ·
Brake actuator assembly ·
CAN communication system ·
Power steering ECU assembly |
On | Ignition switch ON again |
If the power steering ECU assembly has been replaced, perform assist map writing (Click here Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Check if DTC U0129/42 is output.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| U0129/42 is not output |
| U0129/42 is output |
DTC U0129/42 indicates a brake actuator assembly communication malfunction in the power steering system.
U0129/42 is not output
U0129/42 is output
for LHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD with Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD with Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for LHD without Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD without Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD without Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
Check for brake control system DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| Brake control system DTC is not output. |
| Brake control system DTC is output. |
Brake control system DTC is not output.
Brake control system DTC is output.