Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) › from 2015.10
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0048747 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Radio Receiver Power Source Circuit  


DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM

E274383E02
5.24,3.01 6.844,3.25 1.604,0.24 10 false Radio Receiver Assembly 5.24,2.813 5.625,2.99 0.385,0.177 10 false G46 5.396,0.396 5.563,0.573 0.167,0.177 10 false 4 5.375,2.26 5.542,2.438 0.167,0.177 10 false 7 5.406,1.24 5.573,1.417 0.167,0.177 10 false 3 5.698,0.583 6.448,0.813 0.75,0.229 10 false +B1 5.708,1.354 6.458,1.583 0.75,0.229 10 false ACC1 5.708,2.458 6.458,2.688 0.75,0.229 10 false GND1 2.073,1.344 3.677,1.583 1.604,0.24 10 false from ACC Relay 3.927,1.552 4.323,1.771 0.396,0.219 10 false ACC 3.896,0.74 4.896,0.938 1,0.198 10 false RADIO 2.292,0.563 3.167,0.865 0.875,0.302 10 false from Battery 4.406,0.438 4.583,0.625 0.177,0.188 10 false *1 4.417,1.219 4.594,1.406 0.177,0.188 10 false *1 4.406,0.063 4.583,0.25 0.177,0.188 10 false *2 4.417,0.885 4.594,1.073 0.177,0.188 10 false *2 1.115,0.24 1.49,0.469 0.375,0.229 10 false B42 1.083,1 1.542,1.271 0.458,0.271 10 false AC41 1.573,0.896 1.792,1.115 0.219,0.219 10 false 24 1.563,0.125 1.792,0.333 0.229,0.208 10 false 12 0.542,1.365 0.927,1.542 0.385,0.177 10 false G87 0.552,1.573 1.604,2.052 1.052,0.479 10 false Engine Stop and Start ECU*2 0.177,2.969 2.542,3.25 2.365,0.281 10 false *1: w/o Stop and Start System 0.198,3.344 2.563,3.625 2.365,0.281 10 false *2: w/ Stop and Start System

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE)
a.
E259248C09
1.51,0.396 1.896,0.594 0.385,0.198 2.5,1.406 2.135,1.104 true 1.271,1.646 1.594,1.365 true 2.229,0.604 1.927,1 true 0.146,0.115 0.458,0.271 0.313,0.156 10 false *a 1.573,0.417 1.917,0.625 0.344,0.208 10 false G46 2.563,1.333 3.115,1.552 0.552,0.219 10 false +B1 1.063,1.667 1.5,1.865 0.438,0.198 10 false GND1 2.302,0.51 2.854,0.729 0.552,0.219 10 false ACC1
*a Front view of wire harness connector
(to Radio Receiver Assembly)


Disconnect the radio receiver assembly connectors.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G46-7 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
w/o Stop and Start System
Tester Connection Condition Specified Condition
G46-4 (+B1) - Body ground Always 11 to 14 V
G46-3 (ACC1) - Body ground Ignition switch ACC 11 to 14 V
Ignition switch off Below 1 V

w/ Stop and Start System
Tester Connection Condition Specified Condition
G46-4 (+B1) - Body ground Always 10.5 to 14 V
G46-3 (ACC1) - Body ground Ignition switch ACC 10.5 to 14 V
Ignition switch off Below 1 V



Result:
Proceed to
OK
NG (w/o Stop and Start System)
NG (w/ Stop and Start System)



OK

NG (w/o Stop and Start System)

REPAIR OR REPLACE HARNESS OR CONNECTOR

NG (w/ Stop and Start System)