This is the power source circuit to operate the radio and display receiver assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
Disconnect the radio and display receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G141-7 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G141-4 (+B1) - G141-7 (GND1) | Always | 11 to 14 V |
| G141-3 (ACC1) - G141-7 (GND1) | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| G143-1 (IG) - G141-7 (GND1) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G141-4 (+B1) - G141-7 (GND1) | Always | 10.5 to 14 V |
| G141-3 (ACC1) - G141-7 (GND1) | Ignition switch ACC | 10.5 to 14 V |
| Ignition switch off | Below 1 V | |
| G143-1 (IG) - G141-7 (GND1) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG (w/o Stop and Start System) |
| NG (w/ Stop and Start System) |
OK
NG (w/o Stop and Start System)
NG (w/ Stop and Start System)
for 3ZR-FAE: Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 3ZR-FAE)>Backup Boost Converter Circuit
for 2WW: Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>Backup Boost Converter Circuit