85035
1.REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)
85035
2.ADJUST WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)
Select a washer nozzle sub-assembly so that the contact area is within the standard. Replace the washer nozzle sub-assembly with the selected one.
| *a | Washer Fluid Spray Angle | *b | Part Number |
| *c | Identification Mark | - | - |
85035
3.INSTALL WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)