Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › from 2015.10
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0050609 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55412C 3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 55670 4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55680A 5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 83950M 6.REMOVE TELLTALE LIGHT ASSEMBLY

Hide 86120L 7.REMOVE NAVIGATION RECEIVER ASSEMBLY

a.
E332581

Remove the 4 bolts.


b.

Detach the 4 clips and remove the navigation receiver assembly with bracket.


c.

Disconnect each connector.


Hide 86211 8.REMOVE NO. 1 RADIO BRACKET

a.
E339926

Remove the 3 screws and No. 1 radio bracket.


Hide 86212 9.REMOVE NO. 2 RADIO BRACKET

E339927

a.

Remove the 3 screws and No. 2 radio bracket.