Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU(for RHD) › from 2015.10
RM3090E _57 Power Source / Network _008434 NETWORKING _0227721 NETWORK GATEWAY ECU(for RHD) A

NETWORKING  NETWORK GATEWAY ECU(for RHD)  INSTALLATION  


PROCEDURE

Hide 89111 1.INSTALL NETWORK GATEWAY ECU

a.
E339049

Insert the network gateway ECU to the ECU integration box RH.


b.

Push in the network gateway ECU to attach the 2 claws.


Hide 55545 3.INSTALL FUSE BOX OPENING COVER

Hide 55606 4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION