Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL REAR LIGHT ASSEMBLY LH
|
Protective Tape |
Set the rear light assembly LH in place.
Install the 5 nuts.
Connect the connector.
84280D
2.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)
67750
3.INSTALL BACK DOOR TRIM BOARD ASSEMBLY
67938A
4.INSTALL BACK DOOR SIDE GARNISH LH
67937B
5.INSTALL BACK DOOR SIDE GARNISH RH
67939B
6.INSTALL CENTER BACK DOOR GARNISH