Home › Vehicle Interior › LIGHTING (INT) › BACK DOOR COURTESY SWITCH › from 2015.10
RM3090E _58 Vehicle Interior _008429 LIGHTING (INT) _0050310 BACK DOOR COURTESY SWITCH A

LIGHTING (INT)  BACK DOOR COURTESY SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.

·

When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.



PROCEDURE

Hide 69350 1.INSTALL BACK DOOR LOCK ASSEMBLY (BACK DOOR COURTESY SWITCH)

a.

w/ Power Back Door:

i.
B421521

Apply MP grease to the sliding parts of the back door lock assembly (back door courtesy switch).


ii.

Install the back door lock assembly (back door courtesy switch) with the 4 bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


iii.

Connect the connectors.



b.

w/o Power Back Door:

i.
B421522

Apply MP grease to the sliding parts of the back door lock assembly (back door courtesy switch).


ii.

Install the back door lock assembly (back door courtesy switch) with the 3 bolts.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


iii.

Connect the connector.



Hide 67750 2.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 67938A 3.INSTALL BACK DOOR SIDE GARNISH LH

Hide 67937B 4.INSTALL BACK DOOR SIDE GARNISH RH

Hide 67939B 5.INSTALL CENTER BACK DOOR GARNISH