Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM › from 2015.10
RM3090E _58 Vehicle Interior _008782 DOOR LOCK _0051217 POWER DOOR LOCK CONTROL SYSTEM L

DOOR LOCK  POWER DOOR LOCK CONTROL SYSTEM  PRECAUTION  


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



IGNITION SWITCH EXPRESSIONS


a.

The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off (Lock)
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START On (Start)



PRECAUTION WHEN REPLACING MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)


*: w/ Door Control Battery

a.

If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.


b.

As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in On-Vehicle Inspection to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure.*

Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION


c.

If the ECU-B NO.1 fuse (the main power source fuse of the main body ECU [multiplex network body ECU]) is removed with the door control battery charged, power will be supplied to the main body ECU (multiplex network body ECU) from the door control battery for up to 30 minutes. At this time, the main body ECU (multiplex network body ECU) will be able to function with the ECU-B NO.1 fuse (the main power source fuse of the main body ECU [multiplex network body ECU]) removed.*