Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › from 2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0233144 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.


PROCEDURE

Hide 88211B 1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

NOTICE:

If the front bumper assembly or radiator grill has been replaced, check that the beam axis change mechanism is at the standard position (centered).


a.

Set beam axis to the standard position.

i.
E322512E01
1.552,0.458 1.708,0.656 0.156,0.198 10 false A 2.25,0.219 2.406,0.417 0.156,0.198 10 false B

Turn the bolt so that the beam axis change mechanism is positioned as shown in the illustration.

Specified Condition:

Difference between (A) and (B): 1 mm (0.0394 in.) or less




b.

Attach the 2 guides to install the millimeter wave radar sensor assembly.


c.
B421048C02
2.781,1.292 3,1.51 0.219,0.219 10 true (1) 0.427,1.281 0.646,1.5 0.219,0.219 10 true (2) 2.208,0.365 2.427,0.583 0.219,0.219 10 true (3) 1.021,0.281 1.24,0.5 0.219,0.219 10 true (4)
V100135

Screw
V100136

Bolt


Install the 2 screws and 2 bolts.

HINT:

Tighten the bolts and screws in the order shown in the illustration.


Torque:
Bolt : 2.5 N*m (25 kgf*cm, 22 in.*lbf)


Hide 52119A 2.INSTALL FRONT BUMPER COVER

Hide 88211B 3.ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY

a.

If the millimeter wave radar sensor has been replaced, the front of the vehicle has been repaired or modified, or the position of the beam axis change mechanism has been changed, perform adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT