Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2015.10–2016.08
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0048751 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C120B  IG Supply Voltage Low  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
C120B IG Supply Voltage Low Master cylinder pressure sensor power supply voltage decrease occurs or history of voltage decrease exists, and defective master cylinder pressure sensor output continues for 1 second or more.
·

Master cylinder pressure sensor output defective

·

Skid control ECU (Brake actuator assembly)

·

ABS NO. 2 fuse



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION

·

Inspect the fuses for circuits related to this system before performing the following procedure.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (+BS TERMINAL)
a.
C342353C24
1.49,0.104 1.865,0.375 0.375,0.271 0.208,1.656 0.208,1.51 0.208,1.51 0.698,1.24 true 3.135,1.688 3.135,1.542 3.135,1.542 2.688,1.24 true 0.104,0.104 0.417,0.26 0.313,0.156 10 false *a 1.563,0.156 2.021,0.354 0.458,0.198 10 false A80 0.052,1.688 0.667,1.885 0.615,0.198 10 false GND1 3,1.719 3.354,1.906 0.354,0.188 10 false +BS
*a Front view of wire harness connector
(to Skid Control ECU [Brake Actuator Assembly])


Make sure that there is no looseness at the locking part and the connecting part of the connector.


b.

Disconnect the A80 skid control ECU (brake actuator assembly) connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A80-38 (+BS) - Body ground Always 11 to 14 V
A80-38 (+BS) - A80-25 (GND1) Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.RECONFIRM DTC

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (+BS CIRCUIT)

2.RECONFIRM DTC
a.

Reconnect the A80 skid control ECU (brake actuator assembly) connector.


b.

Clear the DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105

c.

Check if the same DTC is recorded.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTC C120B is not output. A
DTC C120B is output. B



A

B