Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR › 2015.10–2016.08
RM3090E _54 Brake _008767 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0230681 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 5.REMOVE BRAKE ACTUATOR WITH BRACKET

a.
C306186

Pull down the lock lever of the wire harness connector toward the front of the vehicle to release the lock.


b.

Disconnect the wire harness connector from the brake actuator assembly.

NOTICE:

Be careful not to allow brake fluid to enter the removed connector.



c.

Disconnect the clamp from the brake actuator assembly.


d.
C306187

Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.


e.
C317498C01
0.646,0.698 1.292,0.698 true 0.656,1.052 1.135,1.052 1.135,1.052 1.49,0.708 true 0.688,1.406 1.073,1.406 1.073,1.406 1.51,0.948 true 2.063,0.885 2.292,1.24 2.292,1.24 2.573,1.24 true 1.719,0.667 2.104,0.219 2.104,0.219 2.406,0.219 true 1.927,0.656 2.26,0.417 2.26,0.417 2.563,0.417 true 2.635,0.344 2.948,0.542 0.313,0.198 10 true *a 0.5,0.604 0.708,0.833 0.208,0.229 10 true *b 0.521,0.969 0.708,1.208 0.188,0.24 10 true *c 2.438,0.125 2.604,0.365 0.167,0.24 10 true *d 2.615,1.146 2.823,1.396 0.208,0.25 10 true *e 0.521,1.333 0.708,1.563 0.188,0.229 10 true *f
*a To Front Wheel Cylinder RH
*b To Front Wheel Cylinder LH
*c To Rear Wheel Cylinder RH
*d To Rear Wheel Cylinder LH
*e From Front Master Cylinder
*f From Rear Master Cylinder


Use tags or make a memo to identify the places to reconnect.


f.
C344847

Remove the 3 nuts and brake actuator with bracket.

NOTICE:

Be careful not to damage the brake tubes.



g.
C344848

Disconnect the 3 clamps from the brake actuator bracket assembly.