Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › from 2015.10
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0047055 AUTOMATIC HIGH BEAM SYSTEM Y

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the automatic high beam system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Measure the vehicle battery voltage.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.


Result:
Proceed to
NEXT



NEXT

3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the CAN communication system is functioning normally.

with Central Gateway ECU

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD with Central Gateway ECU)>PRECAUTION

without Central Gateway ECU

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD without Central Gateway ECU)>PRECAUTION


Result:
Proceed to
CAN communication system DTCs are not output
CAN communication system DTCs are output



CAN communication system DTCs are not output

4.CHECK FORWARD RECOGNITION SYSTEM

CAN communication system DTCs are output

4.CHECK FORWARD RECOGNITION SYSTEM
a.

Use the GTS to check if the lane departure alert system is functioning normally.

Click hereEngine / Hybrid System>CRUISE CONTROL>FORWARD RECOGNITION CAMERA SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING


Result:
Proceed to
Forward recognition camera system DTCs are not output
Forward recognition camera system DTCs are output



Forward recognition camera system DTCs are not output

5.CHECK FOR DTC*

Forward recognition camera system DTCs are output

5.CHECK FOR DTC*

DTCs are not output

6.PROBLEM SYMPTOMS TABLE

DTCs are output

6.PROBLEM SYMPTOMS TABLE

Result:
Proceed to
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table



Fault is not listed in Problem Symptoms Table

7.OVERALL ANALYSIS AND TROUBLESHOOTING*

Fault is listed in Problem Symptoms Table

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

7.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

8.ADJUST, REPAIR OR REPLACE
8.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

9.CONFIRM TEST
9.CONFIRM TEST
Result:
Proceed to
NEXT



NEXT

END