Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
for K111, K111F:
Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>SFI SYSTEM(for K111, K111F)>INITIALIZATION
except K111, K111F:
Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>SFI SYSTEM(except K111, K111F)>INITIALIZATION
89467B
1.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
| *1 | Fulcrum Length |
Using SST, install the air fuel ratio sensor to the exhaust manifold.
Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Make sure SST and the wrench are connected in a straight line.
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
for K111, K111F:
Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>SFI SYSTEM(for K111, K111F)>INITIALIZATION
except K111, K111F:
Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>SFI SYSTEM(except K111, K111F)>INITIALIZATION
Do not damage the air fuel ratio sensor.
Connect the air fuel ratio sensor connector and clamp.
2.INSPECT FOR EXHAUST GAS LEAK