Use the following procedure to troubleshoot the lighting system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the CAN communication system is functioning normally.
for LHD with Central Gateway ECU
for RHD with Central Gateway ECU
for LHD without Central Gateway ECU
for RHD without Central Gateway ECU
| Proceed to |
|---|
| CAN DTC is not output |
| CAN DTC is output |
CAN DTC is not output
CAN DTC is output
for LHD with Central Gateway ECU
for RHD with Central Gateway ECU
for LHD without Central Gateway ECU
for RHD without Central Gateway ECU
Refer to Problem Symptoms Table.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| Fault is not listed in Problem Symptoms Table |
| Fault is listed in Problem Symptoms Table |
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table
Operation Check.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>OPERATION CHECK
Terminals of ECU.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>TERMINALS OF ECU
Data List / Active Test.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT