The illuminated entry system controls the engine switch illumination.
Using the GTS, perform the Active Test.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Power/Engine SW Light | Engine switch Illumination | ON or OFF | - |
| Tester Display |
|---|
| Power/Engine SW Light |
| Proceed to |
|---|
| Engine switch illumination illuminates |
| Engine switch illumination does not illuminates |
Engine switch illumination illuminates
Engine switch illumination does not illuminates
Remove the engine switch.
for 2AD-FHV
Click hereEngine / Hybrid System>2AD-FHV STARTING>ENGINE SWITCH>REMOVAL
for 2AD-FTV
Click hereEngine / Hybrid System>2AD-FTV STARTING>ENGINE SWITCH>REMOVAL
for 2AR-FE
Click hereEngine / Hybrid System>2AR-FE STARTING>ENGINE SWITCH>REMOVAL
for 3ZR-FAE
Click hereEngine / Hybrid System>3ZR-FAE STARTING>ENGINE SWITCH>REMOVAL
for 3ZR-FE
Click hereEngine / Hybrid System>3ZR-FE STARTING>ENGINE SWITCH>REMOVAL
Inspect the engine switch.
for 2AD FHV
Click hereEngine / Hybrid System>2AD-FHV STARTING>ENGINE SWITCH>INSPECTION
for 2AD-FTV
Click hereEngine / Hybrid System>2AD-FTV STARTING>ENGINE SWITCH>INSPECTION
for 2AR-FE
Click hereEngine / Hybrid System>2AR-FE STARTING>ENGINE SWITCH>INSPECTION
for 3ZR-FAE
Click hereEngine / Hybrid System>3ZR-FAE STARTING>ENGINE SWITCH>INSPECTION
for 3ZR-FE
Click hereEngine / Hybrid System>3ZR-FE STARTING>ENGINE SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for 2AD-FHV
Click hereEngine / Hybrid System>2AD-FHV STARTING>ENGINE SWITCH>REMOVAL
for 2AD-FTV
Click hereEngine / Hybrid System>2AD-FTV STARTING>ENGINE SWITCH>REMOVAL
for 2AR-FE
Click hereEngine / Hybrid System>2AR-FE STARTING>ENGINE SWITCH>REMOVAL
for 3ZR-FAE
Click hereEngine / Hybrid System>3ZR-FAE STARTING>ENGINE SWITCH>REMOVAL
for 3ZR-FE
Click hereEngine / Hybrid System>3ZR-FE STARTING>ENGINE SWITCH>REMOVAL
Disconnect the G24 engine switch connector.
Disconnect the G84 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G24-9 (SWIL) - G84-16 (SWIL) | Always | Below 1 Ω |
| G24-6 (AGND) - G84-24 (AGND) | Always | Below 1 Ω |
| G24-9 (SWIL) - Body ground | Always | 10 kΩ or higher |
| G24-6 (AGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG