Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER(for 3ZR-FE, 3ZR-FAE, 2AR-FE) › from 2016.08
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0050031 CONDENSER(for 3ZR-FE, 3ZR-FAE, 2AR-FE) A

HEATING / AIR CONDITIONING  CONDENSER(for 3ZR-FE, 3ZR-FAE, 2AR-FE)  INSTALLATION  


PROCEDURE

Hide 88460 1.INSTALL COOLER CONDENSER ASSEMBLY

a.
E269749

Attach the 2 guides to install the cooler condenser assembly as shown in the illustration.

NOTICE:

Do not damage the condenser or radiator when installing the condenser assembly.


HINT:

If a new cooler condenser assembly is installed, add compressor oil to the condenser as follows.


Capacity:

Add 40 cc (1.35 fl. oz.)


Refrigerant Compressor Oil
HFC-134a (R134a) ND-OIL 8 or equivalent
HFO-1234yf (R1234yf) ND-OIL 12 or equivalent


Hide 16712 2.INSTALL NO. 2 FAN SHROUD

a.

Install the No. 2 fan shroud with the 2 bolts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


b.

Attach the 3 clamps to connect the water by-pass pipe to the No. 2 fan shroud.


Hide 16533B 3.INSTALL NO. 1 RADIATOR SUPPORT

Hide 88706 4.CONNECT LIQUID PIPE SUB-ASSEMBLY

a.

Remove the vinyl tape from the liquid pipe sub-assembly and the connecting part of the cooler condenser assembly.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.

Refrigerant Compressor Oil
HFC-134a (R134a) ND-OIL 8 or equivalent
HFO-1234yf (R1234yf) ND-OIL 12 or equivalent


c.

Install the O-ring to the liquid pipe sub-assembly.


d.

Connect the liquid pipe sub-assembly to the cooler condenser assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 88703 5.CONNECT DISCHARGE HOSE SUB-ASSEMBLY

a.

Remove the vinyl tape from the discharge hose sub-assembly and the connecting part of the cooler condenser assembly.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.

Refrigerant Compressor Oil
HFC-134a (R134a) ND-OIL 8 or equivalent
HFO-1234yf (R1234yf) ND-OIL 12 or equivalent


c.

Install the O-ring to the discharge hose sub-assembly.


d.

Connect the discharge hose sub-assembly to the cooler condenser assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 16681A 6.INSTALL RADIATOR UPPER AIR GUIDE PLATE

Hide 52029 7.INSTALL FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY

Hide 53301 9.ADJUST HOOD SUB-ASSEMBLY

Hide 10.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT