88211B
1.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Pre-crash Safety System)
89348D
2.REMOVE ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)
89341A
3.REMOVE NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
86790B
4.REMOVE FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
85045
5.REMOVE TYPE 1 HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY LH (w/ Headlight Cleaner System)
85044
6.REMOVE TYPE 1 HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY RH (w/ Headlight Cleaner System)
Use the same procedure described for the LH side.
7.REMOVE HEADLIGHT CLEANER HOSE (w/ Headlight Cleaner System)
85208A
8.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)
85207A
9.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)
Use the same procedure described for the LH side.
81220
10.REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)
81210A
11.REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)
Use the same procedure described for the LH side.
82113
12.REMOVE NO. 3 ENGINE ROOM WIRE
Detach each clamp and remove the No. 3 engine room wire.
| *A | w/ Pre-crash Safety System | *B | w/ TOYOTA Parking Assist-sensor System |
52128C
13.REMOVE FRONT BUMPER HOLE COVER LH
| *A | w/o Fog Light |
| *B | w/ Fog Light |
Remove the clip.
Detach the 5 claws and remove the front bumper hole cover LH.
52127D
14.REMOVE FRONT BUMPER HOLE COVER RH
Use the same procedure described for the LH side.
52722
15.REMOVE FRONT BUMPER EXTENSION MOULDING LH (w/ Fog Light)
Detach the 3 claws and remove the front bumper extension moulding LH.
52721
16.REMOVE FRONT BUMPER EXTENSION MOULDING RH (w/ Fog Light)
Use the same procedure described for the LH side.
52114A
17.REMOVE FRONT BUMPER EXTENTION MOUNTING BRACKET
Remove the 2 screws and front bumper extension mounting bracket.
53101
18.REMOVE RADIATOR GRILLE SUB-ASSEMBLY
53112E
19.REMOVE LOWER NO. 1 RADIATOR GRILLE
Detach the 16 claws and 2 guides and remove the lower No. 1 radiator grille.
52113D
20.REMOVE FRONT BUMPER EXTENSION LH
Remove the 5 clips and front bumper extension LH.
52112D
21.REMOVE FRONT BUMPER EXTENSION RH
Use the same procedure described for the LH side.
53286C
22.REMOVE FRONT BUMPER ARM HOLE COVER LH
Detach the 4 claws and guide and remove the front bumper arm hole cover LH.
53285J
23.REMOVE FRONT BUMPER ARM HOLE COVER RH
Use the same procedure described for the LH side.
53113E
24.REMOVE LOWER NO. 2 RADIATOR GRILLE
Remove the 2 clips.
Detach the 22 claws and remove the lower No. 2 radiator grille.
53128A
25.REMOVE LOWER RADIATOR GRILLE LH
for Automatic Transaxle (U660F):
Remove the 2 screws.
Detach the 2 claws and 2 guides and remove the duct.
Remove the clip and open the lower radiator grille LH as shown in the illustration.
| *A | for Automatic Transaxle (U660F) |
| *B | except Automatic Transaxle (U660F) |
Remove the 2 clips.
Detach the 4 claws and remove the lower radiator grille LH.
52414
26.REMOVE FRONT BUMPER GUARD PAD LH
| *a | Clip A |
| *b | Clip B |
Remove the clip labeled A.
Remove the clip labeled B and front bumper guard pad LH.
52413A
27.REMOVE FRONT BUMPER GUARD PAD RH
Use the same procedure described for the LH side.
52411
28.REMOVE FRONT BUMPER GUARD
Remove the 2 clips.
Remove the front bumper guard as shown in the illustration.
52711
29.REMOVE FRONT BUMPER MOULDING
Remove the 11 clips and front bumper moulding.