In some cases, wireless door lock control functions are normal but the hazard warning light and/or wireless door lock buzzer answer-back function* does not operate. In such cases, hazard warning light and wireless door lock buzzer* signal outputs from the main body ECU (multiplex network body ECU) may be malfunctioning.
*: w/ Wireless Door Lock Buzzer Answer Back Function
The wireless door lock control system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the wireless door lock control system after confirming that the communication systems are functioning properly.
When replacing the main body ECU (multiplex network body ECU), make sure to replace it with a new one.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Customize Setting / Wireless Door Lock.
Select the setting by referring to the table below.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Hazard Answer Back | When the doors are locked by wireless operation, the hazard warning lights flash once.
When the doors are unlocked by wireless operation, the hazard warning lights flash twice.*4 |
ON | 0:OFF,1:ON | Main body ECU (Multiplex network body ECU) |
| Wireless Buzzer Resp | Wireless door lock buzzer response*1 | ON | 0:OFF,1:ON | Main body ECU (Multiplex network body ECU) |
| Wireless Buzzer Vol | Wireless door lock buzzer volume*1 | Level 5*2
Level 7*3 |
0000:Level7,0001:Level6,0010:Level5,0011:Level4,0100:Level3,0101:Level2,0110:Level1,0111:Level0 | Main body ECU (Multiplex network body ECU) |
*1: w/ Wireless Door Lock Buzzer Answer Back Function
*2: w/ Power Back Door System
*3: w/o Power Back Door System
*4: for the vehicles displaying the Item "Hazard Answer Back" on the GTS
| Proceed to |
|---|
| Both items are ON and except Level 0 |
| Either item is OFF or Level 0 |
Both items are ON and except Level 0
Either item is OFF or Level 0
Check the wireless door lock control function using the electrical key transmitter sub-assembly.
| Proceed to |
|---|
| Wireless door lock/unlock operates properly |
| Wireless door lock/unlock does not operate properly |
Wireless door lock/unlock operates properly
Wireless door lock/unlock does not operate properly
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| FR Door Lock Pos | Front door RH unlock detection switch signal | LOCK or UNLOCK | LOCK: Front door RH locked
UNLOCK: Front door RH unlocked |
- |
| FL Door Lock Pos | Front door LH unlock detection switch signal | LOCK or UNLOCK | LOCK: Front door LH locked
UNLOCK: Front door LH unlocked |
- |
| RR-Door Lock Pos SW | Rear door RH and LH unlock detection switch signal | ON or OFF | ON: Rear door RH or LH unlocked
OFF: Rear door RH and LH locked |
*1 |
| RL-Door Lock Pos SW | Rear door RH and LH unlock detection switch signal | ON or OFF | ON: Rear door RH or LH unlocked
OFF: Rear door RH and LH locked |
*2 |
*1: When checking RR-Door Lock Pos SW, make sure to check it with the rear door LH locked.
*2: When checking RL-Door Lock Pos SW, make sure to check it with the rear door RH locked.
| Tester Display |
|---|
| FR Door Lock Pos |
| FL Door Lock Pos |
| RR-Door Lock Pos SW |
| RL-Door Lock Pos SW |
The display on the GTS changes according to the detection condition of the door unlock detection switch.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the wireless answer-back operation using the electrical key transmitter sub-assembly.
| Proceed to |
|---|
|
*: w/ Wireless Door Lock Buzzer Answer Back Function |
| Only wireless door lock buzzer answer-back does not occur* |
| Only hazard warning light answer-back does not occur |
Only wireless door lock buzzer answer-back does not occur*
Only hazard warning light answer-back does not occur
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Restrict Condition |
|---|---|---|---|
| Wireless Buzzer | Wireless door lock buzzer | OFF or ON | - |
| Tester Display |
|---|
| Wireless Buzzer |
| Proceed to |
|---|
| Wireless door lock buzzer does not turn on or off |
| Wireless door lock buzzer turns on or off (for LHD) |
| Wireless door lock buzzer turns on or off (for RHD) |
Wireless door lock buzzer does not turn on or off
Wireless door lock buzzer turns on or off (for LHD)
Wireless door lock buzzer turns on or off (for RHD)
Disconnect the A12 wireless door lock buzzer connector.
Disconnect the 3B instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A12-1 (B) - 3B-55 | Always | Below 1 Ω |
| A12-2 (E) - Body ground | Always | Below 1 Ω |
| A12-1 (B) - Body ground | Always | 10 kΩ or higher |
| 3B-55 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the instrument panel junction block assembly.
for LHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL
for RHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3B-55 - A-21 (BZR) | Always | Below 1 Ω |
| 3B-55 or A-21 (BZR) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG (for LHD) |
| NG (for RHD) |
OK
NG (for LHD)
NG (for RHD)
Temporarily replace the wireless door lock buzzer with a new one or normally functioning one.
Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK BUZZER>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Check the operation of the wireless answer-back function.
Wireless answer-back function operates normally.
| Proceed to |
|---|
| OK |
| NG (for LHD) |
| NG (for RHD) |
OK
NG (for LHD)
NG (for RHD)
Check that the hazard warning lights blink when the hazard warning signal switch is pressed.
Hazard warning lights blink.
| Proceed to |
|---|
| OK (for LHD) |
| OK (for RHD) |
| NG |
OK (for LHD)
OK (for RHD)
NG