Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › from 2016.08
RM3090E _52 Drivetrain _008762 AXLE AND DIFFERENTIAL _0049348 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42312B 2.REMOVE REAR AXLE SHAFT NUT LH (for 4WD/AWD)

C130587

a.

Using SST and a hammer, unstake the staked part of the rear axle shaft nut.

SST
09930-00010  (09931-00010, 09931-00020)

NOTICE:

Loosen the staked part of the rear axle shaft nut completely, otherwise the screw of the drive shaft may be damaged.



b.

While applying the brakes, remove the rear axle shaft nut.


Hide 3.DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

a.
C130579

Remove the 2 bolts, and disconnect the rear disc brake caliper assembly.

NOTICE:

Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.



Hide 42431 4.REMOVE REAR DISC

Hide 89516B 5.DISCONNECT SKID CONTROL SENSOR WIRE (for 2WD)

C346173

a.

Disconnect the connector.


Hide 6.DISCONNECT REAR SPEED SENSOR LH (for 4WD/AWD)

C130581

a.

Remove the bolt and disconnect the rear speed sensor from the rear axle carrier.

NOTICE:
·

Prevent foreign matter from attaching to the sensor tip.

·

Be careful not to damage the rear speed sensor.

·

Clean the installation hole and the surface for the speed sensor every time the speed sensor is removed.




Hide 42450B 7.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (for 2WD)

a.
C130589

Remove the 4 bolts and the rear axle hub and bearing assembly.


Hide 42440 8.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (for 4WD/AWD)

C130590

a.

Remove the 4 bolts from the rear axle carrier.


b.

Using a plastic-faced hammer, remove the rear axle hub and bearing assembly LH.