Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for SD) › from 2016.08
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0104513 NAVIGATION SYSTEM(for SD) C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for SD)  B158C  SD Card Communication Malfunction  


DESCRIPTION

The navigation receiver assembly stores this DTC when the SD card cannot be mounted when inserted into the SD card slot.

DTC No. Detection Item DTC Detection Condition Trouble Area
B158C SD Card Communication Malfunction The SD card cannot be mounted when inserted into the SD card slot.
·

SD card

·

Navigation receiver assembly



CAUTION / NOTICE / HINT

NOTICE:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.CHECK SD CARD
a.

Turn the ignition switch off and remove the SD card from the SD card slot.


b.

Check that the SD card is not damaged.

OK:

The SD card is not damaged.



Result:
Proceed to
OK
NG



OK

2.CLEAN COMPONENTS

NG

REPLACE SD CARD

2.CLEAN COMPONENTS
a.

Check that the terminals of the SD card are free of foreign matter. Remove foreign matter as necessary.


b.

Check that the SD card slot of the navigation receiver assembly is free of foreign matter. Remove foreign matter as necessary.


c.

Insert the SD card into the SD card slot.


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for SD)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for SD)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (FOREIGN MATTER IS ADHERED TO SD CARD OR SD CARD SLOT)

NG

4.REPLACE SD CARD
4.REPLACE SD CARD
a.

Replace the SD card.


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for SD)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Recheck for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for SD)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (SD CARD IS DEFECTIVE)

NG