The side collision sensor LH circuit consists of the airbag sensor assembly and floor side airbag sensor LH.
The floor side airbag sensor LH detects impacts to the vehicle and send signals to the airbag sensor assembly to determine if the SRS should be deployed.
DTC B163A is stored when a malfunction is detected in the floor side airbag sensor LH or airbag sensor assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Test Mode / Check Mode |
|---|---|---|---|---|---|
| B163A | Side Airbag Sensor Assembly No.2 (LH) | Either condition is met:
·
A floor side airbag sensor LH malfunction. ·
An airbag sensor assembly malfunction. |
·
Floor side airbag sensor LH ·
Airbag sensor assembly |
Comes on | Not applicable |
When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
After replacing the airbag sensor assembly, refer to initialization.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
| *1 | Floor Side Airbag Sensor RH |
| *2 | Airbag Sensor Assembly |
Turn the power switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.
Interchange the floor side airbag sensor LH with RH and connect the connectors to them.
Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
Turn the power switch on (IG), and wait for at least 60 seconds.
Clear the DTCs stored in memory.
Turn the power switch off.
Turn the power switch on (IG), and wait for at least 60 seconds.
Check for DTCs.
| Proceed to |
|---|
| DTC B163A is output |
| DTC B162A is output |
| DTCs B162A and B163A are not output |
Codes other than DTCs B162A and B163A may be output at this time, but they are not related to this check.
Turn the power switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.
Return the floor side airbag sensor RH and LH to their original positions and connect the connectors to them.
DTC B163A is output
DTC B162A is output
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SIDE AIRBAG SENSOR (for Center Pillar)>REMOVAL
DTCs B162A and B163A are not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING