DTC B1787 is stored when the occupant detection ECU receives a collision detection signal sent by the rear occupant classification sensor LH in the case of an accident.
DTC B1787 is also stored when the front seat assembly RH is subjected to a strong impact, even if an actual accident did not occur.
If the vehicle was not in a collision, but the occupant detection ECU receives a collision detection signal and stores DTC B1787, the DTC can be cleared by performing zero point calibration.
Therefore, if DTC B1787 is output, first perform zero point calibration.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1787 | Rear Occupant Classification Sensor LH Collision Detection | ·
Rear occupant classification sensor LH sensed large load. ·
Front seat adjuster assembly RH malfunction |
Front seat adjuster assembly RH (Rear occupant classification sensor LH)* |
*: The rear occupant classification sensor LH is built into the front seat adjuster assembly RH.
When this DTC is stored, repair of the malfunction indicated can only be performed by initializing the occupant detection ECU or replacing the front seat adjuster assembly RH. Do not replace the occupant detection ECU to repair the malfunction indicated by this DTC.
If the occupant detection ECU is replaced, this DTC will not be output but the occupant detection system may not function properly.
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
When DTC B165A is stored as a result of troubleshooting for the airbag system, check the DTCs stored in the occupant detection ECU. When DTC B1787 is output, perform troubleshooting for this DTC first.
Using the GTS, perform "Zero Point Calibration".
| Tester Display |
|---|
| Zero Point Calibration |
"Zero Point Calibration is complete." is displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs stored in the occupant detection ECU.
Clear the DTCs stored in the airbag sensor assembly.
Turn the engine switch off.
Turn the engine switch on (IG), and wait for at least 60 seconds.
Check the DTCs stored in the occupant detection ECU.
| Proceed to |
|---|
| DTC B1785 is output. |
| DTC B1785 is not output. |
Codes other than DTC B1785 may be output at this time, but they are not related to this check.
DTC B1785 is output.
DTC B1785 is not output.
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Replace the front seat adjuster assembly RH with a new one.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, perform "Zero Point Calibration".
| Tester Display |
|---|
| Zero Point Calibration |
| Proceed to |
|---|
| NEXT |
NEXT