If the hands free power back door function does not operate, it could indicate the certification ECU (smart key ECU assembly) did not transmit a power back door open request signal, or a malfunction in the power back door system.
When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
The entry and start system (for Entry Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Entry Function) after confirming that the communication systems are functioning properly.
After repair, confirm that no DTCs are output.
Check that there are no electrical key transmitter sub-assemblies in the vehicle.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Customize Setting / PSD & PBD operation.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Kick Sensor Function | Function that enables/disables the hands free power back door | ON | 0:OFF,1:ON | Multiplex network door ECU |
| Kick Sensor Operation with ACC ON | Status of the hands free power back door function with engine switch on (ACC). | Available | 0:Available,1:Not Available | Multiplex network door ECU |
| Result | Proceed to |
|---|---|
| The customize setting is "ON" and "Available" | A |
| The customize setting is "OFF" or "Not Available" | B |
A
B
Enter the following menus: Body Electrical / Entry&Start / Utility / Operation History.
| Tester Display |
|---|
| Operation History |
| Parameter Name | Content |
|---|---|
| Kick Sensor Open Request Signal. | The multiplex network door ECU receives kick detection signals from the kick door control sensor and sends certification requests to the certification ECU (smart key ECU assembly). If certification is OK, an open permission is sent to the multiplex network door ECU. |
| Result | Proceed to |
|---|---|
| Not output | A |
| "Kick Sensor Open Request Signal" is output | B |
A
B
While carrying the electrical key transmitter sub-assembly, check that the entry unlock function operates when the back door opener switch is operated.
| Result | Proceed to |
|---|---|
| Entry lock/unlock function does not operate | A |
| Entry lock/unlock function operates | B |
A
B