Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM
RM3620E _58 Vehicle Interior _076039 PRE-COLLISION _0369995 PRE-COLLISION SYSTEM T

PRE-COLLISION  PRE-COLLISION SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.



Pre-Collision System
Symptom Suspected Area Link
"VSC Turned Off Pre-Collision Brake System Unavailable" is displayed Check whether VSC is off -
Electronically controlled brake system (w/ Vacuum Brake Booster) Click here
Electronically controlled brake system (w/o Vacuum Brake Booster) Click here
Pre-collision system cannot be canceled (PCS warning light does not illuminate) Combination meter assembly (check if indicator illuminates using Active Test) Click here
Meter / gauge system Click here
Steering pad switch assembly Click here
Combination meter assembly Click here