When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
55474B
1.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH
55410C
2.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
83100
3.REMOVE COMBINATION METER ASSEMBLY
Remove the 4 screws.
|
Remove in this Direction |
Pull towards the rear of the vehicle to detach the clip and guide and remove the combination meter assembly.
| *A | for 4.2 Inch Display |
| *B | for 7 Inch Display |
Detach the clamp and disconnect the 2 connectors.