The brake booster with master cylinder assembly (skid control ECU) sends a stop light operation request signal to the stop light control relay (stop light switch assembly). When the brake booster with master cylinder assembly (skid control ECU) detects a malfunction relating to the stop light circuit, the forward recognition camera is notified via CAN communication, and C142571 is output.
The brake actuator assembly (skid control ECU) sends a stop light operation request signal to the stop light control relay (stop light switch assembly). When the brake actuator assembly (skid control ECU) detects a malfunction relating to the stop light circuit, the forward recognition camera is notified via CAN communication, and C142571 is output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C142571 | Stop Light Relay Actuator Stuck | for HV Model:
Once 3 seconds elapse after turning the ignition switch to ON, the system receives a stop light circuit malfunction signal from the brake booster with master cylinder assembly (skid control ECU) for approximately 1 second or more. for Gasoline Model:
Once 3 seconds elapse after turning the ignition switch to ON, the system receives a stop light circuit malfunction signal from the brake actuator assembly (skid control ECU) for approximately 1 second or more. |
Electronically controlled brake system |
Check electronically controlled brake system.
for HV Model:
for Gasoline Model:
for HV Model:
When C142571 is detected by the pre-collision system, C1380 may also be detected in the electronically controlled brake system. Therefore, check the electronically controlled brake system first when C142571 is detected.
for Gasoline Model:
When C142571 is detected by the pre-collision system, C13807E or C13807F may also be detected in the electronically controlled brake system. Therefore, check the electronically controlled brake system first when C142571 is detected.
| Proceed to |
|---|
| NEXT |
NEXT