Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM
RM3620E _58 Vehicle Interior _076039 PRE-COLLISION _0369995 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U041881  Invalid Data Received from Brake System Control Module Invalid Serial Data Received  


DESCRIPTION

for HV Model:
·

The forward recognition camera receives signals from the brake booster with master cylinder assembly (skid control ECU) corresponding to the brake control status via the CAN communication line.

·

When a brake control system malfunction signal is received from the brake booster with master cylinder assembly (skid control ECU), the forward recognition camera outputs U041881.


for Gasoline Model:
·

The forward recognition camera receives signals from the brake actuator assembly (skid control ECU) corresponding to the brake control status via the CAN communication line.

·

When a brake control system malfunction signal is received from the brake actuator assembly (skid control ECU), the forward recognition camera outputs U041881.


DTC No. Detection Item DTC Detection Condition Trouble Area
U041881 Invalid Data Received from Brake System Control Module Invalid Serial Data Received
for HV Model:

Once 3 seconds elapse after turning the ignition switch to ON, the forward recognition camera receives a brake control system malfunction signal from the brake booster with master cylinder assembly (skid control ECU) for approximately 1 second or more.


for Gasoline Model:

Once 3 seconds elapse after turning the ignition switch to ON, the forward recognition camera receives a brake control system malfunction signal from the brake actuator assembly (skid control ECU) for approximately 1 second or more.


for HV Model:
·

Forward recognition camera

·

Brake booster with master cylinder assembly (skid control ECU)


for Gasoline Model:
·

Forward recognition camera

·

Brake actuator assembly (skid control ECU)



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.

HINT:

Forward recognition camera adjustment can be performed by using either "One Time Recognition" or "Sequential Recognition".

One Time Recognition:

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)

Sequential Recognition:

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)




PROCEDURE

1.CHECK ELECTRONICALLY CONTROLLED BRAKE SYSTEM
a.

Check the DTCs.

for HV Model:

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

for Gasoline Model:

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/ Vacuum Brake Booster)>DTC CHECK / CLEAR

Chassis > Brake/EPB > Trouble Codes
50001 435
OK:

Electronically controlled brake system DTCs are not output.


HINT:

If U041881 is output in the pre-collision system, electronically controlled brake system DTCs may also have been output. Check the electronically controlled brake system first.



Result:
Proceed to
OK
NG



OK

REPLACE FORWARD RECOGNITION CAMERA

NG