Home › Drivetrain › CLUTCH › CLUTCH SYSTEM
RM3620E _52 Drivetrain _076045 CLUTCH _0370080 CLUTCH SYSTEM N

CLUTCH  CLUTCH SYSTEM  BLEEDING  


CAUTION / NOTICE / HINT

NOTICE:

Wash off clutch fluid immediately if it comes in contact with any painted surface.


HINT:
·

If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed air from the clutch hydraulic system.

·

In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and the bleeder before bleeding.



PROCEDURE

Hide 17750A 1.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 2.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 4.REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP

Hide 5.FILL RESERVOIR WITH BRAKE FLUID

Hide 6.BLEED CLUTCH LINE

C403484C01
1.677,1.406 2.625,0.625 2.625,0.625 2.906,0.625 true 0.927,1.49 1.615,1.49 true 3.01,0.531 3.323,0.729 0.313,0.198 10 false *1 0.74,1.396 0.99,1.604 0.25,0.208 10 true *2
*1 Bleeder Plug Cap
*2 Bleeder Plug


a.

Remove the bleeder plug cap.


b.

Connect a vinyl tube to the bleeder plug.


c.

Depress the clutch pedal 5 times, and then loosen the bleeder plug while the pedal is depressed. *1


d.

When fluid no longer comes out, tighten the bleeder plug, and then release the clutch pedal. *2


e.

Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out.

NOTICE:

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while replacing the brake fluid.



f.

Check that all the air has been bled from the clutch line.


g.

Tighten the bleeder plug.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


h.

Depress the clutch pedal 10 times or more and confirm its operation.

NOTICE:

This must be performed before the engine is started.



i.

Install the bleeder plug cap.


Hide 7.INSPECT FLUID LEAK

Hide 9.INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP

Hide 10.INSTALL CENTER COWL TOP VENTILATOR LOUVER

Hide 11.INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 17750A 12.INSTALL INLET AIR CLEANER ASSEMBLY