When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.
30300
1.REMOVE MANUAL TRANSAXLE ASSEMBLY
for EG62F:
Click hereDrivetrain>EG62F (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSAXLE ASSEMBLY>REMOVAL
31488F
2.REMOVE BLEEDER TO FLEXIBLE HOSE TUBE
Using a 10 mm union nut wrench, disconnect the bleeder to flexible hose tube from the clutch release bleeder sub-assembly.
Remove the bolt and bleeder to flexible hose tube from the manual transaxle assembly.
Remove the clamp from the bleeder to flexible hose tube.
31400
3.REMOVE CLUTCH RELEASE CYLINDER WITH BEARING ASSEMBLY
| *a | Adapter |
Using a screwdriver, pull out the clip of the adapter.
Remove the 2 bolts.
| *1 | Clutch Release Cylinder with Bearing Assembly To Bleeder Tube |
| *a | Adapter |
Disconnect the adapter from the clutch release cylinder with bearing assembly to bleeder tube.
| *a | Adapter |
Push the clip into the adapter.
Remove the clutch release cylinder with bearing assembly from the manual transaxle assembly.
31482F
4.REMOVE CLUTCH RELEASE CYLINDER WITH BEARING ASSEMBLY TO BLEEDER TUBE
Using a 10 mm union nut wrench, disconnect the clutch release cylinder with bearing assembly to bleeder tube from the clutch release bleeder sub-assembly.
Remove the bolt and clutch release cylinder with bearing assembly to bleeder tube from the manual transaxle assembly.
Remove the clamp from the clutch release cylinder with bearing assembly to bleeder tube.
31407B
5.REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY
Remove the bolt and clutch release bleeder sub-assembly from the manual transaxle assembly.
31210
6.REMOVE CLUTCH COVER ASSEMBLY
| *a | MatchMarkS |
Put matchmarks on the clutch cover assembly and flywheel sub-assembly.
Loosen each bolt one turn at a time in the order shown in the illustration until the spring tension is released.
Remove the set bolts and pull off the clutch cover assembly.
Do not drop the clutch disc assembly.
31250
7.REMOVE CLUTCH DISC ASSEMBLY
Keep the lined part of the clutch disc assembly, the pressure plate and the surface of the flywheel sub-assembly away from oil and foreign matter.