The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit.
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Disconnect the radio receiver assembly connector.
Disconnect the No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G16-10 (UDO+) - G106-3 (US1+) | Always | Below 1 Ω |
| G16-9 (UDO-) - G106-2 (US1-) | Always | Below 1 Ω |
| G16-12 (UJSS) - G106-5 (USG1) | Always | Below 1 Ω |
| G16-10 (UDO+) - Body ground | Always | 10 kΩ or higher |
| G16-9 (UDO-) - Body ground | Always | 10 kΩ or higher |
| G16-12 (UJSS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG