Home › Drivetrain › UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH
RM3620E _52 Drivetrain _076122 UB80E AUTOMATIC TRANSMISSION / TRANSAXLE _0370669 PARK / NEUTRAL POSITION SWITCH N

UB80E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  ADJUSTMENT  


CAUTION / NOTICE / HINT

NOTICE:

Before adjusting the park/neutral position switch assembly, check that the shift lever is in N.


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 33820B 2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 84540 3.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
C402661

Disconnect the park/neutral position switch assembly connector.


b.
C402662

Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.


c.
C402663

Loosen the 2 bolts of the park/neutral position switch assembly.


d.
C402664C01
0.917,1.5 1.083,1.5 1.083,1.5 1.615,0.865 true 2.083,1.75 1.865,1.75 1.865,1.75 1.865,1.031 true 2.115,1.667 2.281,1.833 0.167,0.167 10 true *a 0.708,1.417 0.875,1.583 0.167,0.167 10 true *b
*a Neutral Basic Line
*b Protrusion


Align the protrusion with the neutral basic line.


e.

Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


f.

Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


g.

Connect the park/neutral position switch assembly connector.


Hide 33820B 4.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 84540 5.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION