The blind spot monitor sensor receives vehicle speed signals from the skid control ECU assembly via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A45 | Vehicle Speed Sensor | A fail flag is transmitted from the skid control ECU assembly | ·
Electronically controlled brake system ·
Blind spot monitor sensor RH ·
Blind spot monitor sensor LH |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Check for electronically controlled brake system DTCs.
for HV Model
for Gasoline Model
Electronically controlled brake system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for HV Model
for Gasoline Model
Turn the ignition switch off.
Turn the ignition switch to ON.
Recheck for DTCs and check if the same DTC is output again.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| No DTCs are output. | A |
| DTC C1A45 is output ("Blind Spot Monitor Master"). | B |
| DTC C1A45 is output ("Blind Spot Monitor Slave"). | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C