Home › Drivetrain › EG62 (MANUAL TRANSMISSION / TRANSAXLE) › SPEED SENSOR
RM3620E _52 Drivetrain _076270 EG62 MANUAL TRANSMISSION / TRANSAXLE _0371318 SPEED SENSOR A

EG62 MANUAL TRANSMISSION / TRANSAXLE  SPEED SENSOR  INSTALLATION  


PROCEDURE

Hide 89413B 1.INSTALL TRANSMISSION REVOLUTION SENSOR

a.

Clean the bolt and installation hole in the manual transmission case.


b.

Coat a new O-ring with gear oil and install it to the transmission revolution sensor.


c.
P000601C54
1.958,1.573 1.667,1.833 false 1.583,1.854 1.833,2.094 0.25,0.24 10 false *a
*a Adhesive


Apply adhesive to 2 or 3 threads on the end of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent


NOTICE:

Make sure to install the bolt immediately after applying adhesive to prevent foreign matter from attaching to it.



d.

Install the transmission revolution sensor to the manual transmission case with the bolt.

Torque:
7.8 N*m (80 kgf*cm, 69 in.*lbf)


e.

Connect the transmission revolution sensor connector.


Hide 2.INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 17750A 3.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY