33820B
1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
Before adjusting the transmission control cable assembly, check that the shift lever position sensor and shift lever are in N.
Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.
| *a | Align the hole on the transmission control cable bracket with the protrusion of the vehicle body. |
Connect the transmission control cable assembly to the vehicle body with the nut.
Do not deform the transmission control cable bracket.
Connect the transmission control cable assembly to the inverter with converter assembly with the 3 bolts.
Turn the control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.
Engage the 2 claws to install a new clip to the transmission control cable assembly.
| *1 | Transmission Control Cable Assembly |
| *2 | No. 1 Transmission Control Cable Bracket |
| *a | Claw (A) |
| *b | Claw (B) |
Using a screwdriver, engage the 4 claws and install the transmission control cable assembly to the No. 1 transmission control cable bracket.
Make sure that the claws (A) of the clip are securely engaged in the grooves of the bracket.
Make sure that the transmission control cable assembly is securely installed inside of the claws (B) of the clip.
Connect the transmission control cable assembly to the control shaft lever with the nut.
33820B
2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
58861B
3.INSTALL NO. 1 CONSOLE BOX DUCT
58810J
4.INSTALL CONSOLE BOX ASSEMBLY
17410
5.INSTALL FRONT EXHAUST PIPE ASSEMBLY
51420
6.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
51441
7.INSTALL NO. 1 ENGINE UNDER COVER
53895B
8.INSTALL FRONT FENDER FRONT SPLASH SHIELD RH
53896B
9.INSTALL FRONT FENDER FRONT SPLASH SHIELD LH
10.INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
17750A
11.INSTALL INLET AIR CLEANER ASSEMBLY
12601B
12.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
13.INSPECT SHIFT LEVER POSITION
14.ADJUST SHIFT LEVER POSITION