1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
53896B
2.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
53895B
3.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
51441
4.REMOVE NO. 1 ENGINE UNDER COVER
51420
5.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
17750A
6.REMOVE INLET AIR CLEANER ASSEMBLY
12601B
7.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
8.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
G125A
9.DISCONNECT MOTOR COOLING COOLER
Remove the 3 bolts to disconnect the motor cooling cooler from the No. 1 transmission control cable bracket.
33820B
10.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Move the shift lever to N.
Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.
Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with the clip from the No. 1 transmission control cable bracket.
Using a screwdriver, disengage the 2 claws and remove the clip from the transmission control cable assembly.
89451A
11.REMOVE SHIFT LEVER POSITION SENSOR
Disconnect the shift lever position sensor connector.
Remove the nut, washer and transmission control shaft lever from the shift lever position sensor.
| *1 | Lock Plate |
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, pry out the tabs of the lock plate.
| *1 | Lock Nut |
| *2 | Lock Plate |
Remove the lock nut and lock plate from the shift lever position sensor.
Remove the 2 bolts and shift lever position sensor from the hybrid vehicle transaxle assembly.