Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM
RM3620E _58 Vehicle Interior _076050 LIGHTING (INT) _0371654 LIGHTING SYSTEM U

LIGHTING (INT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ACC SW Ignition switch ACC signal OFF or ON ON: Ignition switch ACC
OFF: Ignition switch off
"ON" is also displayed for this item when the ignition switch is ON.
IG SW Ignition switch ON signal OFF or ON ON: Ignition switch ON
OFF: Ignition switch off
"OFF" is also displayed for this item when the ignition switch is ACC.
RR Door Courtesy SW Rear door courtesy light switch assembly RH signal OFF or ON OFF: Rear door RH closed
ON: Rear door RH open
-
RL Door Courtesy SW Rear door courtesy light switch assembly LH signal OFF or ON OFF: Rear door LH closed
ON: Rear door LH open
-
Back Door Courtesy SW Back door courtesy light switch signal OFF or ON OFF: Back door closed
ON: Back door open
-
FR Door Lock Pos Front door RH unlock detection switch signal LOCK or UNLOCK LOCK: Front door RH locked
UNLOCK: Front door RH unlocked
-
FR Door Courtesy SW Front door courtesy light switch assembly RH signal OFF or ON OFF: Front door RH closed
ON: Front door RH open
-
FL Door Lock Pos Front door LH unlock detection switch signal LOCK or UNLOCK LOCK: Front door LH locked
UNLOCK: Front door LH unlocked
-
FL Door Courtesy SW Front door courtesy light switch assembly LH signal OFF or ON OFF: Front door LH closed
ON: Front door LH open
-
RR-Door Lock Pos SW Rear door RH unlock detection switch signal*1
Rear door RH and rear door LH unlock detection switch signal*2
OFF or ON OFF: Rear door RH unlocked*1
OFF: Rear door RH and rear door LH unlocked*2
ON: Rear door RH locked*1
ON: Rear door RH or rear door LH locked*2
-
RL-Door Lock Pos SW Rear door LH unlock detection switch signal*1
Rear door LH and rear door RH unlock detection switch signal*2
OFF or ON OFF: Rear door LH unlocked*1
OFF: Rear door LH and rear door RH unlocked*2
ON: Rear door LH locked*1
ON: Rear door LH or rear door RH locked*2
-
Interior Light Control Operation of the illuminated entry system OFF or ON Customized setting displayed Displayed only when All Data is selected.
I/L ON W/Door Key Unlock Function that lights up the interior lights when the doors are unlocked OFF or ON Customized setting displayed Displayed only when All Data is selected.
Lighting Time Lighting time of the delay control function (illuminated entry system) 15s, 7.5s or 30s Customized setting displayed Displayed only when All Data is selected.
Room Light when Aprchd Function that lights up the interior lights when a key enters any actuation area OFF or ON Customized setting displayed Displayed only when All Data is selected.
Inside Foot Light Function that lights up the No. 1 interior illumination light assembly (footwell light)*3 OFF or ON Customized setting displayed Displayed only when All Data is selected.
I/L when ACC OFF Function that lights up the interior lights when the ignition switch is turned from ACC or ON to off OFF or ON Customized setting displayed Displayed only when All Data is selected.
Light Control Function that lights up the ambient lights (while driving) OFF or ON Customized setting displayed Displayed only when All Data is selected.

*1: w/ Memory Call Function

*2: w/o Memory Call Function

*3: w/ Footwell Light




ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Main Body / Active Test.


ii.

Body Electrical / Entry&Start / Active Test.*

*: w/ Entry and Start System




e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Illuminated Entry System Turns on the lights that are controlled by the illuminated entry system*1 OFF or ON Perform the Active Test with the DOOR switch in the map light assembly, No. 1 room light assembly and transponder key coil*4 turned on.
Fr Foot Light Operation of the following lights:
·

No. 1 interior illumination light assembly (footwell light)

·

No. 2 interior illumination light assembly (footwell light)

·

No. 3 interior illumination light assembly (center tray light)*2

·

No. 4 interior illumination light assembly (driver side tray light)*2

·

No. 5 interior illumination light assembly (front passenger side tray light)*2

·

No. 6 interior illumination light assembly (cup holder light)*3


OFF or ON w/ Footwell Light
Relay for Interior Light Auto Cut Function DOME CUT relay DOME CUT relay When performing this Active Test, turn all the interior lights on.
·

OFF: DOME CUT relay on (interior lights turn on)

·

ON: DOME CUT relay off (interior lights turn off)


Dimmer Signal Outputs night mode (dimmer signal) OFF or ON -

*1: Refer to Operation Check for the lights that are controlled by the illuminated entry system.

Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>OPERATION CHECK

*2: w/ Tray Light

*3: w/ Cup Holder Light

*4: w/o Entry and Start System


Body Electrical > Entry&Start > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Power/Engine SW Light Push start switch illumination OFF or ON -