This circuit consists of the No. 2 clearance warning buzzer and clearance warning ECU assembly. An ECU-excited type buzzer is used. The ECU operates the buzzers using a sound pattern that changes depending on the distance to the obstacle.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Clearance Sonar / Active Test.
Check that the buzzer operates by performing the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Rear Buzzer | No. 2 clearance warning buzzer | Operate or Stop | Confirm that the vehicle is stopped and the ignition switch is ON |
| Tester Display |
|---|
| Rear Buzzer |
The No. 2 clearance warning buzzer sounds.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G25*1 or H4*2 clearance warning ECU assembly connector.
*1: for LHD and Manual Transaxle
*2: except LHD and Manual Transaxle
Disconnect the M13 No. 2 clearance warning buzzer connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G25-15 (BBZ) - M13-1 | Always | Below 1 Ω |
| G25-16 (ER) - M13-2 | Always | Below 1 Ω |
| G25-15 (BBZ) or M13-1 - Body ground | Always | 10 kΩ or higher |
| G25-16 (ER) or M13-2 - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H4-15 (BBZ) - M13-1 | Always | Below 1 Ω |
| H4-16 (ER) - M13-2 | Always | Below 1 Ω |
| H4-15 (BBZ) or M13-1 - Body ground | Always | 10 kΩ or higher |
| H4-16 (ER) or M13-2 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the No. 2 clearance warning buzzer with a new or known good one.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Clearance Sonar / Active Test.
Check that the buzzer operates by performing the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Rear Buzzer | No. 2 clearance warning buzzer | Operate or Stop | Confirm that the vehicle is stopped and the ignition switch is ON |
| Tester Display |
|---|
| Rear Buzzer |
The No. 2 clearance warning buzzer sounds.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for LHD: Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for LHD)>REMOVAL
for RHD: Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for RHD)>REMOVAL