The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft oil seal LH and front drive shaft oil seal RH removal/installation are shown below.
1.REMOVE FRONT DRIVE SHAFT ASSEMBLY
43457
2.REMOVE DRIVE SHAFT BEARING BRACKET
43420H
3.REMOVE FRONT DRIVE SHAFT OIL SEAL LH
Using SST, remove the front drive shaft oil seal LH from the continuously variable transaxle assembly.
Be careful damage the continuously variable transaxle assembly.
43410M
4.REMOVE FRONT DRIVE SHAFT OIL SEAL RH
Using SST, remove the front drive shaft oil seal RH from the continuously variable transaxle assembly.
Be careful damage the continuously variable transaxle assembly.
43410M
5.INSTALL FRONT DRIVE SHAFT OIL SEAL RH
| *a | Inner Lip |
| *b | Outer Lip |
Using SST and a hammer, install a new front drive shaft oil seal RH to the continuously variable transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
| *a | Correct |
| *b | Incorrect |
| *c | Outer Lip |
Make sure that the outer lip of the front drive shaft oil seal RH is not pinched by SST.
Do not allow foreign matter to attach to the inner lip and outer lip of the front drive shaft oil seal RH.
Do not install the front drive shaft oil seal RH at an angle.
Do not remove the grease from the inner lip and outer lip of the front drive shaft oil seal RH.
43420H
6.INSTALL FRONT DRIVE SHAFT OIL SEAL LH
| *a | Inner Lip |
| *b | Outer Lip |
Using SST and a hammer, install a new front drive shaft oil seal LH to the continuously variable transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
| *a | Correct |
| *b | Incorrect |
| *c | Outer Lip |
Make sure that the outer lip of the front drive shaft oil seal LH is not pinched by SST.
Do not allow foreign matter to attach to the inner lip and outer lip of the front drive shaft oil seal LH.
Do not install the front drive shaft oil seal LH at an angle.
Do not remove the grease from the inner lip and outer lip of the front drive shaft oil seal LH.
43457
7.INSTALL DRIVE SHAFT BEARING BRACKET
8.INSTALL FRONT DRIVE SHAFT ASSEMBLY