Home › Drivetrain › K120 (MULTIDRIVE / CVT) › PARK / NEUTRAL POSITION SWITCH
RM3620E _52 Drivetrain _076272 K120 MULTIDRIVE / CVT _0371724 PARK / NEUTRAL POSITION SWITCH N

K120 MULTIDRIVE / CVT  PARK / NEUTRAL POSITION SWITCH  ADJUSTMENT  


CAUTION / NOTICE / HINT

NOTICE:

Before adjusting the park/neutral position switch assembly, check that the shift lever is in N.


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
·
C332327

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 33820B 2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 84540 3.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
C400910

Disconnect the park/neutral position switch assembly connector.


b.
C416212C01
1.031,1.417 1.417,1.417 true 0.823,1.302 1.021,1.531 0.198,0.229 10 true *a
*a Piece of Wood or Equivalent


Using a piece of wood or equivalent to secure the transmission control shaft lever to prevent it from rotating, remove the nut, washer and transmission control shaft lever from the manual valve lever shaft.

NOTICE:
C416210C01
1.615,0.552 1.823,0.25 1.823,0.25 1.99,0.25 true 1.958,1.344 2.25,0.938 2.25,0.938 2.729,0.938 true 1.531,1.813 1.99,1.813 true 2.042,0.146 2.323,0.385 0.281,0.24 10 false *1 2.792,0.813 3.073,1.052 0.281,0.24 10 false *a 1.323,1.708 1.521,1.938 0.198,0.229 10 true *b
*1 Transmission Control Shaft Lever
*a Manual Valve Link Lever Sub-assembly
*b Manual Valve


If the transmission control shaft lever is not secured when loosening the nut, the manual valve link lever sub-assembly may separate from the manual valve.



c.
C400912

Loosen the 2 bolts of the park/neutral position switch assembly.


d.
C400915C02
2.542,0.469 2.948,0.417 2.948,0.417 2.542,0.635 true 3,0.302 3.198,0.521 0.198,0.219 10 false *a
*a Protrusion


Align the protrusions of the park/neutral position switch assembly as shown in the illustration.


e.

Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


f.

Install the transmission control shaft lever to the manual valve lever shaft with the washer and nut.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


g.

Connect the park/neutral position switch assembly connector.


Hide 33820B 4.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 84540 5.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION