Home › Drivetrain › K120 (MULTIDRIVE / CVT) › TRANSMISSION WIRE
RM3620E _52 Drivetrain _076272 K120 MULTIDRIVE / CVT _0371729 TRANSMISSION WIRE A

K120 MULTIDRIVE / CVT  TRANSMISSION WIRE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission wire removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Transmission valve body assembly
·

Reset transaxle compensation code

·

Perform reset memory

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


for Initialization:(Click here)
for Registration:(Click here)
CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)
Air bleed oil pump with motor assembly (w/ Stop and Start System) Stop and start system (Click here)

PROCEDURE

Hide 35410J 1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

Hide 82125M 2.REMOVE TRANSMISSION WIRE

a.
C401422C02
1.146,1.292 1.302,1.49 0.156,0.198 10 false -
V113147

Remove in this Direction


Detach the claw, rotate the lever and disconnect the transmission wire connector.


b.
C399131

Disconnect the transmission revolution sensor (NC1) connector.


c.
C401424

Remove the bolt and transmission wire from the transaxle case sub-assembly.


d.
C395524

Remove the O-ring from the temperature sensor.