The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission valve body assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
Shift shock may increase after replacing the transmission valve body assembly. In this case, shift shock will reduce as the vehicle in driven.
35015Y
1.REMOVE TRANSAXLE SIDE COVER SUB-ASSEMBLY
35410J
2.REMOVE TRANSMISSION VALVE BODY ASSEMBLY
Detach the clamp to disconnect the transmission wire from the solenoid lock plate.
Disconnect the 6 solenoid valve connectors.
Remove the bolt and temperature sensor clamp from the transmission valve body assembly.
Disconnect the temperature sensor from the transmission valve body assembly.
Remove the O-ring from the temperature sensor.
Remove the 11 bolts and transmission valve body assembly from the transaxle case sub-assembly.
Make sure the manual valve does not fall out when removing the transmission valve body assembly, as the manual valve is not secured to the transmission valve body assembly.
Remove the front oil pump cover gasket from the transaxle case sub-assembly.
Remove the 4 transaxle case gaskets from the transaxle case sub-assembly.