Home › Power Source / Network › A25A-FXS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › 2018.10–2020.08
RM3620E _57 Power Source / Network _076184 A25A-FXS BATTERY / CHARGING _0372192 BATTERY CURRENT SENSOR A

A25A-FXS BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for HV model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for HV model) (Click here)
Reset back door close position Power back door system (for HV model) (Click here)
Power back door initialization Power door lock control system (Click here)

NOTICE:

After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 58410B 2.REMOVE DECK BOARD ASSEMBLY

Hide 58416K 3.REMOVE REAR NO. 2 FLOOR BOARD

Hide 65351A 4.REMOVE BATTERY HOLE COVER

Hide 28850C 5.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A432055

Remove the nut and disconnect the No. 2 frame wire from the battery state sensor assembly.

NOTICE:

When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



b.
A432056

Loosen the nut and remove the battery state sensor assembly from the auxiliary battery.


c.
A432057

Disconnect the battery state sensor assembly connector.


d.

Detach the clamp and disconnect the engine wire from the battery state sensor assembly.


e.
A432058

Detach the 2 claws to remove the battery state sensor assembly from the battery current sensor holder.